HP 800/900/1000/1100/1200/1600, Snap & Fill
HP 51645A/G, HP 51640/A
Supplies you should have before you begin: Paper towel, latex gloves because ink can and does make a mess plan for this before you begin filling cartridges. You may want to fill them initially in a sink as you gain experience using the Snap & Fill.
A.
1. Place your 45G/A cartridge in the Snap N Fill as shown in the above photo.
2. Screw the Snap N Fill hose end luer fitting to the syringe .
3. Pull back on the syringe slowly. This will remove any excess air from the cartridge.
4. Disconnect hose end luer fitting from Snap N Fill.
B.
1. Using the Plastic Ink Tip provided attach the tip to the syringe, insert the syringe tip into your bottle of ink drawing out 35cc of ink.
2. Remove the Ink Tip from the syringe and attach the Snap N Fill hose end to the syringe.
3. Gently press the plunger of the syringe to begin filling the cartridge. After all the ink has been dispensed into cartridge, remove the cartridge from the Snap N Fill. Wipe all visible ink from cartridge printhead with a lint free cloth. A kleenex works well.
4. Insert the cartridge back into the printer and run a cleaning cycle per your printer instructions.