Epson Stylus Color 900
1. Seal the outlet hole(s) in the base of the cartridge with the aluminum tape provided. A separate piece over each hole
2. Push needle through the label all the way into the cartridge of the correct filling hole. Very slowly inject ink into the sponge until the cartridge is full. The black cartridge will hold up to 10 ml. of inks. The color cartridge will hold up to 5 ml. of each color.
3. Seal the hole(s) made in the top label with a small piece of aluminum tape provided. If the holes are not sealed properly the cartridge will leak.
4. Clean the syringe with warm water and dry for future use, or use with a different color ink.
5. Replace the cartridge leaving the aluminum tape on the outlet hole(s) and run the cleaning cycle as per printer instructions. If necessary leave cartridge in printer for up to 24 hours. (This allows ink to flow to the print head).
NOTE: If cartridge is refilled before it is completely empty this time is greatly reduced.