STEP 1
1. It is recommended that you leave the cartridges in the cartridge carriage to refill them. This will keep air from reaching the bottom of the cartridge. Refill the cartridges over the sink for easy clean up of any over spill.
2. Remove the label from your cartridge.
3. Locate the round indentation (original fill hole) on the top of the
cartridge. (as shown in diagrams)
FIGURE 1.
4. You are now ready to inject the ink.
Refilling the cartridge
1. Using the syringe, draw out approximately 12ml of the desired
ink.
2. Insert needle into the hole you just made and inject the ink.
3. DO NOT fill the cartridge right to the top leave a little space.
4. After refilling the cartridge cut a small piece of the aluminum
tape provided to cover the hole you drilled and rub it down with your fingernail.
Again, try to make the seal airtight.
IMPORTANT:
MAKE SURE THAT THE TAPE SEALS THE HOLE SO THAT
IT IS AIRTIGHT, OR ELSE THE INK WILL LEAK INTO YOUR PRINTER. INKS UNLIMITED"WILL
NOT" ACCEPT ANY RESPONSIBILITY IF THIS HAPPENS.
5. Rinse out the needle in warm water and store for later use.