BROTHER LC02 

1. Remove cover by using a small flat blade screwdriver and pry the tang holding the cover on the cartridge. Clean the cartridge of any residual ink that may be on the bottom of the cartridge around the out let hole.  Cover the outlet hole with a small piece of aluminum tape provided.  

2. Remove the factory aluminum seal using a pocket knife.

3.  You will find two small holes in the oval indentation.  The small hole that is located over the sponge area is the hole you need to use to fill the cartridge.  

4. Insert the syringe through the filling hole, and push it all the way into the cartridge.  

5. Slowly inject up to 7 ml. of ink and reseal both the filling hole and breather port with a small piece of aluminum tape that is provided.

6. Replace the cover by snapping the cover back onto the cartridge.

7. Unused ink may be returned to the bottle.  Rinse the syringe with warm water and dry for future use, or use with a different color ink.

8. Replace the cartridge(s) and run a priming/cleaning cycle as per printer instructions.